Assembly (Continued)
Handle Bar C3410
Install the handlebar:
1. | Use the 4 mm hex wrench to remove |
| the lower cap retaining screws from |
| the handlebar bracket. Remove the cap |
| from the bracket, and note the position |
| of the two 2" long spacers to be installed |
| between the bracket halves. See Figure 5. |
2. | Position the handle on the outer tube |
Handle Positioning Label
| POSITION HANDLE |
Handlebar | FORWARD OF THIS LINE |
| |
bracket | Bands |
|
| forward of Handle Positioning Label |
| as shown in Figure 5. Reassemble the |
| lower cap to the handlebar bracket in |
| the reverse order of disassembly. |
3. | Locate the handle in the best position for |
| operator comfort. |
4. | Firmly tighten both lower cap retaining |
Spacer
Lower Cap
Retaining Screws
27009B
Spacer
Lower Cap
Handle Bar
screws. |
5. Secure the cable to the outer pipe with |
the two bands provided in the tool kit. |
See Figure 5. |
Figure 5 | C3410 |
Adjustments
Adjust Throttle Lever Free Play
The throttle lever free play should be approximately
If it becomes necessary to adjust the lever free play, follow the procedures and illustrations that follow.
Throttle Free Play
Figure 6
Figure 7
1.Loosen the air cleaner cover knob and remove the air cleaner cover. See Figure 7.
2.Loosen the lock nut on the cable adjuster. See Figure 8.
3.Turn the cable adjuster in or out as required to obtain proper free play
4.Tighten the locknut.
Cable Lock
Adjuster Nut
Figure 8
5. Reinstall the air cleaner cover.
7