Assembly
Cutting Attachment Shield
Socket- | Bracket | |
| ||
Head Cap | Outer | |
Screw | ||
Tube | ||
|
Shim
Clamp Screw
| Shim |
| |
Retaining | Cutting | Cutting | |
Nut | Attachment Mounting | ||
Attachment | |||
| Plate | ||
| Shield | ||
|
|
Figure 9
Cutting Attachment Shield
Line Cutter
| |
Figure 9A | Line Cutter |
|
Install the Cutting Attachment Shield C3410.
1.Insert the cutting attachment shield between the outer tube and the cutting attachment mounting plate.
See Figure 9.
NOTE:
It may be necessary to loosen the retaining nut and clamp screw to adjust cutting attach- ment shield mounting plate.
WARNING!
NEVER operate the unit without the cutting attachment shield installed and tightly secured!
Sub-Shield C3410.
(when trimmer head is in use)
1.Attach the shield extension to the cutting attachment shield. See figure 9B.
Cutting Attachment Shield
Hook
Receiver
2. Fit the two shims and the bracket over |
the outer tube and loosely install the |
four |
WARNING!
Figure 9B
Hook
3. Tighten the four |
to secure the cutting attachment shield. |
CAUTION!
Make sure the clamp screw and retaining nut are securely tightened before tightening the four
NEVER use this machine without
CAUTION!
Make sure the
6