Installing a Trimmer Head
NOTE:
The C3410 is shipped with Holder A, the blade retainer (safety clip), Holder B, shaft bolt, and bolt guard installed. The shaft bolt is a
CLOCKWISE!
Shaft Bolt (not used)
Bolt Guard
Gear Case
Shaft
1.With the gear case output shaft facing up, rotate the gearshaft and holder A until the hole in holder A aligns with the matching hole in the gear case flange, and then lock the holder to the gear by inserting the long end of the hex wrench through both holes. See Figure 10.
2.Using the combination spark plug/ screwdriver wrench, remove the shaft bolt and bolt guard. See Figure 10.
NOTE:
(not used)
Holder B
Holder A
Figure 10
Hex Wrench
Figure 11
Make sure holder B is installed on the gear- case with the splined hole engaging the gear- case shaft.
3.Using the hex wrench to secure Holder A , install and
See Figure 11.
5.Remove the hex wrench from the gear case and holder.
The C3410 should now be completely assembled to operate as a trimmer.
8