Introduction
Prepare to Assemble
NOTES
This manual contains information for the proper assembly, operation and care of your SP518 sprayer. Carefully read and follow the instructions contained in this manual before operat- ing your sprayer.
Unpack the following items shipped in your sprayer box:
■ Wand |
■ Pump Lever and |
Wand Tank
Pump
Chamber
Packing Ring
Nut
Lever
Wand
Nozzle
Cap
Vent
Diaphragm
Tank
Trigger Valve
THE SERIAL NUMBER IS LOCATED ON THE BOTTOM OF THE TANK.
Connecting Rod |
■ Tank Assembly
■ | Small Parts Kit | Trigger | |
Valve | |||
|
|
■From inside the
sprayer tank, |
|
|
|
remove the |
|
|
|
plastic bag from | Connecting | Pump | Small parts Manual |
the tank strainer. | Rod | Lever | Kit |
Hitch Pins and Washers
Wand Holder
Small Parts included in the plastic bag
Specifications |
| Install the Shaft |
Net Weight | 11 pounds (5.0 kg) |
Tank Capacity | 4.75 U.S. gallons (18 liters) |
Tank Material | Polyethylene |
Fill Opening Diameter | 4.5 inches (114 mm) |
Pump Type/Material | Piston/Brass |
Operating Pressure | |
Wand Assembly Length | 29.5 inches (749 mm) |
Hose Length | 69.75 inches (1771 mm) |
Nozzle Installed | Red Adjustable Cone |
Specifications subject to change without notice.
1.Fit the pump lever shaft into the hole in the sprayer base as shown.
(chamber side).
2.Push the pump lever shaft in until the hole in the shaft matches the opening in the base reinforcement.
3.Lock the shaft in place with the shaft retaining pin.
Shaft Retaining
Pin
Base
Reinforcement
Pump Lever
Shaft
Install the Wand Holders
Fold the wand holders
around the pump lever | 2.5 in. |
connecting rod, then secure | (60 mm) |
with the screws provided. |
|
Screw | 12 in. |
| (300 mm) |
Wand |
|
Holder |
|
Connecting |
|
Rod |
|
2 | 11 |