Stopping the Engine
Idle the engine briefly before stopping (about 2 minutes), then slide the igni- tion switch to the “O” (Engine OFF) position.
Adjusting Engine Idle
The engine must return to idle speed whenever the throttle lever is released. Idle speed is adjustable, and must be set low enough to permit the engine clutch to disengage the cutting attachment.
WARNING!
The cutting attachment must NEVER rotate at engine idle! If the idle speed cannot be adjusted by the procedure described
here, return the trimmer to your Shindaiwa dealer for inspection.
IGNITION SWITCH
OFF
Idle Speed Adjustment
1.Place the trimmer on the ground, then start the engine, and then allow it to idle
2.If the attachment rotates when the engine is at idle, reduce the idle speed by turning the idle adjustment screw
3.If a tachometer is available, the engine idle speed should be final adjusted to 3,000 (±300) rpm
4.Carburetor fuel mixture adjustments are preset at factory and cannot be serviced in the field.
Idle
Adjusting
Screw
Checking Unit Condition
NEVER operate the unit with the pro- tective devices (ignition switch, etc.) removed!
ALWAYS make sure the PowerBroom tool is properly installed and firmly tightened before operation.
Use only authorized Shindaiwa parts and accessories with your Shindaiwa Multipurpose Tool. Do not make modi- fications to your machine without the written approval of Shindaiwa.
NEVER use a cracked or warped Pow- | NEVER allow the engine to run at high | |
RPM without a load. Doing so could | ||
erBroom drum or axle: replace it with a | ||
damage the engine. | ||
serviceable one. | ||
| ||
ALWAYS stop the engine immediately | NEVER operate a machine with worn | |
or damaged fasteners or attachment | ||
and check for damage if you strike a for- | ||
holders. | ||
eign object or if the machine becomes | ||
| ||
tangled. Do not operate with broken or |
| |
damaged equipment. |
|
12