Assembly (continued)
Sweeper Assembly
2 | Secure the drum |
| axle to the shaft |
Clevis
Pin
Hitch
Pin
Install drum
1 axle onto output shaft
Drum Axle
Cotter
Pin
3
Secure with a
cotter pin
4 | Install the sweeper drum |
| assembly |
Drum |
|
Assembly |
|
1.Push one of the drum axles onto either of the two gearcase output shafts. If necessary, rotate the drum axle until the clevis pin hole in the axle aligns with the matching hole in the gearcase output shaft.
CAUTION!
The two drum assemblies are identical, but each drum must be installed with its recessed end facing toward the gearcase.
2.Use a clevis pin and hitch pin to secure the drum axle to the shaft.
3.Slide the recessed end of a sweeper drum assembly over the installed axle, and then push the drum down the axle until the cotter pin hole in the axle extends above the drum surface.
4.Use a cotter pin to secure the drum assembly on the axle (see inset). The cotter pin is designed to fit tightly against the outboard end of the drum, so you may need to com- press the drum face slightly during installation. spead the ends of the cotter pin to secure.
5.Repeat Steps
The PowerBroom tool should now be completely assembled.
8