SCOOTER TILLER CONTROLS (FIG 7)
Speed Controls
The speed control allows you to set a speed between 1 (minimum) and 10 (maximum).
Battery Level Indicator Gauge
Where the needle sits, shows the amount of charge left in your batteries. The amount of charge will only show at its true level when the scooter is in drive.
Caution – Do not allow the gauge needle to go down completely as complete discharge of the batteries could cause irreversible damage.
Horn
A yellow button at the rear of the tiller operates the horn.
Hand Lever Controls
The left hand lever (yellow) controls the reverse and the right hand lever (black) controls the forward motion. The amount of pressure applied to each lever will determine the speed the scooter travels at. Release the lever and the scooter will automatically come to a stop as the electromagnetic brake is applied to the motor.
On/Off Key Switch
Insert the key in the right side of the tiller. Turn the key and the battery gauge needle will move. There may be a slight delay before the hand lever control can be operated, while the controller checks the circuits.
Electromagnetic Brake
The brake is automatically operated when the control levers are pressed or released. There is a slight delay when the scooter decelerates; this allows the scooter to come to a smooth stop.
Battery Level
Indicator Gauge
Hand Lever
Control (Reverse)
Horn Button
Figure 7
8/12/20049
Speed
Control Dial
Hand Lever
Control (Forward)
On/Off
Key Switch
