330002 | Dust Collector |
Figure 6: With the housing on its side, position the base
pan so the straight side faces towards the front.
5.Attach the legs to the base pan (47) with four screws (41), lock washers (42) and nuts (43). Hand tighten all eight fasteners.
Install the Rear Wheels
6.With the Dust Collector still on its side, install the rear wheels, by inserting a re- tainer (44) into a 5/8. socket (or
7.Slip a wheel (45) onto the wheel shaft with the three spoke side facing the retainer. Place a suitable block under the base pan or lift it by hand. Insert the shaft through the base pan’s wheel ‘.haft holes.
8.Put the other wheel on the wheel shaft with the three spoke side facing out. In- stall the other retainer cap and tap it se- curely against the wheel shaft end with a mallet.
9.Set the unit upright.
Tighten the Leg Screws
10.Using a 1/2" socket and. ratchet wrench to hold the nuts (43), tighten the leg screws (41) securely with a large Phillips screw- driver.
Attach the Rear Handle
11.Attach the handle (33) to the back of the legs, using cap screws (31) with lock wash- ers (32) under the cap screw heads.
Tighten the Rear Handle Screws
12.Using a 7/16" wrench, tighten the capscrews (31) which hold the handle (33).
Install Snap-in Plugs and Left Leg Cap
13.Insert the
Install Filter Hood
14.Slip the bent tab of the metal retaining strap (2) through the loop of the rack (3), making sure that the writing on the rack is on the outside (see Figure 7).
Figure 7: Assemble the hood retaining strap, rack and clamp, and feed through the hem in the filter hood.
15.With the bent tab of the strap on the inside of the rack; feed the pointed end of the strap through the hem of the filter hood (1) until the pointed end comes out through the other slot in the hem.
16.Put the pointed end of the strap through the loop in the clamp nut (4) (see Figure 7) so there is at least 1/2" of the strap to bend.
Page 9
