BEFORE INSTALLING THE UNIT
Transport Lock Screws
The mechanism in the CD changer is "locked" into place during shipment by the transport screws. Be sure to remove the screws prior to installation.
Caution
After removing the transport lock screws, place the supplied seals over the screw
holes. These seals are used to keep dust out of the unit, which could cause a malfunction.
Installation and Wiring Precautions
1To prevent a
lBe sure to turn off the ignition and remove the negative
Note
If the changer is to be installed in a car that is equipped with an
2Do not install the unit in the following locations. lLocations exposed to direct sunlight. lWhere hot air is discharged from the car heater. lIn areas subject to extreme temperatures.
3Incorrect installation can cause the sound to "skip" when playing a disc. Mount the unit firmly in place, using the supplied brackets and screws.
4
5
Be careful not to damage the car wiring.
lBe sure to use the supplied screws.
lBe careful not to snag any wires when tightening screws.
lDo not use any of the screws that are part of the brake or steering system, to install the unit.
6lInstall the unit as closely to vertically or horizontally as possible. If the unit must be inclined, the angle must be 15° or less.
Installation and inclination angle
| Horizontal mounting |
| Vertical mounting |
|
|
|
|
|
|
Installation
15° max.
15° max.
Angle
7ID (Identity) Switch for 2nd CD Changer
When used with a compatible controller, an additional CD changer can be installed. When an additional CD changer has been attached in this fashion, the ID switch is used to indicate the number of each respective changer unit.
Changer Identity Switch
Do not use this switch if only 1 CD changer is being used.
Refer to the manual of the divider unit for further details on 2 changer operation.
Changer Identity Switch
3