WIRING
RF output (89.1MHz or 88.7MHz)
Antenna socket
To +12V ACC, Speaker
FM Radio
FM Modulator
Fuse 2A
Fuse 5A
DIN connection cord (6 pin)
DIN cable CD changer (8pin)
To car antenna
+12 volt Accessory/Switched
(ORANGE/WHITE STRIPE)
Connect this wire to a point which is energized when the ignition switch is turned to the "ON" or "ACCESSORY" position.
+12 volt Constant (GREEN/WHITE STRIPE)
Connect this lead to the cable to which power is continu- ously supplied and which has been passed through the vehicle's fuse block.
Ground (BLACK)
Screw this to a metal part of the vehicle. Clean connecting area of paint, dirt, etc. Poor ground can cause damage and affect playability.
Display Unit
INTERFERENCE ON 89.1 MHz
lIf a clear signal cannot be obtained on 89.1 MHz, change the position of the frequency select switch on the back of the FM Modulator and tune the radio to 88.7 MHz when using the CD changer.
lSelect a frequency before mounting the FM Modulator.
Radio sensitivity is slightly reduced when the FM Modulator is connected.
Installation of the FM Modulator:
Install the FM Modulator to the mounting surface with the included tapping screws (M3 x 12).
(M3 x 12)
Driver
Display unit
FM Modulator
6