Shopsmith none installation manual Procedure for Vertical Installation

INSTALLATION (2)

Procedure for Vertical Installation

Note

If the anti-vibration spring position has been changed and verified for vertical mounting (as shown on page 3), start with step 2.

1

It is necessary to change the spring attachment position.

1)Remove the lock screws on the side of the set using a Phillips screwdriver.

2)Turn the spring attachment to the (V) mark side using a screwdriver.

3)Replace the removed screws on the (V) mark side.

H

2

Attach bracket (L) and bracket (R) to each side of the unit, using the hexagonal bolts with washer base (M5 x 8).

Bracket (R)

Hexagonal bolt with washer base

3

Determine the mounting location, and drill four mounting holes.

Never mount the unit near the fuel tank.

4

Mount the unit in place, using four self-tapping screws (M5 x 12).

Use RTV (silicone sealer) on screw threads or around the holes to prevent moisture intrusion.

Self-tapping screw (M5 x 12)

Drill holes 4 mm in diameter.

Bracket (R)

5