BRIDGED CONNECTION
If the amplifier is used in the Bridged MtKie, to prevent the risk of electric shock the following instructions describe the only acceptable method of connection (see illustration).
Voltages in the Bridged Connection ate hazardous to life.Make all
~e w n n e l .
1.Thread the speaker lead through the hole in the supplied connector cover plate.
2.Loosen the insulated red locking cap on the binding post, strip the end of the speaker lead (approximately 19 mm [3/4 in.]), and insert the stripped wire into the hole in the bindmg post. Twist the stripped wire around the post and tighten the locking cap.
Attach the cover plate over the binding post terminal and fasten it with the supplied screws.
NOTE: To ensure correct Bridged Mode speaker polarity, connect the plus (+) terminal of Channel 1 only to the plus speaker terminal and connect the plus terminal of Channel 2 only to the minus (- ) speaker terminal.
C O N N E C T I O N DETAIL
BRIDGED CONNECTION
SPECIFICATIONS
Frequency Response (Flat Mode ') 20 Hz to 20 kHz +0.5 dB
Power Output
100 watts minimum per channel into 8 ohms with less than 0.1% THD
Input Impedance
100 kilohms
RecommendedMinimum Output Load Impedance
4 ohms
Input Sensitivity (Full Power Output in Flat Mode')
0dBV (1.0 V)
Dynamic Range
Greater than 100 dB from noise level to clipping (300 Hz to 20 kHz)
Power Requirements 120 Vac f lo%,60 Hz
CeMcations
Listed by Underwriters Laboratories Inc.
Overall Dimensions 102mmHx429mmWx356mmD(4x 1 6 % 14in~.)
Weight
12.3kg (27 lb)
'In other modes Frequency Response and Sensitivityare tailored to complement the individual HTS Loudspeakers' FrequencyResponse and Sensitivity
