ENGLISH |
| ENGLISH |
INSTALLING BATTERIES
UP4 Receiver
FIGURE 11
1.Locate the battery door on the bottom of the unit. Release the battery door by sliding the door in the direction of the arrow until the pins on either side of the door are visible. Flip open the battery door once it is released.
2.Insert a fresh 9 volt battery, with terminals facing down, observing the proper polarity
3.Return the battery door to its original position and slide the pins back into the lock position.
NOTE: The battery door can be opened when the UP4 receiver is mounted on a camera, allowing the battery to be replaced without dismounting the unit. If two receivers are mounted on the same camera, the top receiver and box will need to be dismounted in order to open the battery door on the bottom unit.
UC1 or U1 Body-Pack Transmitter
UC1 | U1 |
FIGURE 12
1. Make sure the transmitter power ON/OFF switch is in the OFF position.
1.5V AA
1.5V AA 
2.Open the transmitter battery compartment by squeezing the two tabs on either side of the transmitter. Then flip the battery cover down. Refer to Figure 12.
3.To remove battery:
UC1: Lift up on the edge of the battery remove it.
U1: Press down on negative terminal end of each battery.
4. Insert a new 9V battery (UC1) or two fresh 1.5V AA batteries (U1) in the compartment. Maintain proper battery polarity
UC2 or U2 Hand–Held Transmitter
UC2 | U2 |
FIGURE 13
1.Make sure the transmitter power ON/OFF switch is in the OFF position.
2.Unscrew the battery cover. On the U2, Slide the cover down once it has been unscrewed.
3.Pull down on the old battery and remove it (UC2) or lift the batteries out (U2).
4.Install a fresh 9V alkaline battery (UC2) or two fresh 1.5 V AA batteries (U2). Maintain proper battery polarity
– 7 –
