en
21
Door cannot be closed.
Door lock has been activated.
To reset, close the door with
greater force.
... changing settings
A setting cannot be changed,
a programme starts.
Wrong programme button pressed.
Terminate the programme
(see chapter entitled “Terminating
the programme (Reset)”) and start
all over again.
You did not wait until programme
ended.
Cover on the detergent dispenser
cannot be closed.
Detergent dispenser overfilled
or mechanism blocked by sticky
detergent residue.
Detergent residue in the detergent
dispenser.
Dispenser was damp when filled.
“check water supply”
4
display
lights up.
Tap turned off.
Water supply interrupted.
Supply hose kinked.
Filter in the water supply blocked.
Switch off the appliance and
pull out the mains plug.
Turn off the tap.
Clean filter in the supply hose.
Reconnect power supply.
Turn on the tap.
Switch on the appliance.
Water is left in the appliance
at the end of the programme.
(E24) Waste water hose is
blocked or kinked.
(E25) Waste water pump
blocked, cover on the waste
water pump is not locked in
position (see Maintenance
and Care).
Filters blocked.
The programme has not yet
ended. Wait until programme
ends (digital display indicates
0:00) or implement the ”Reset”
function.
Refill indicator for salt
5
and/or
rinse-aid
6
is not lit.
Refill indicator/s switched off.
Adequate salt/rinse-aid available.
Refill indicator for special salt
5
is lit.
No salt.
Refill with salt.
Sensor does not detect salt
tablets.
Use different special salt.
... during the wash cycle
Unusual foam formation
Handwash liquid in the rinse
aid dispenser.
Spilled rinse-aid causes excessive
frothing, therefore please remove
with a cloth.
Appliance stops during the wash
cycle.
Power supply interrupted.
Water supply interrupted.
Knocking/rattling noise during
rinsing
Spray arm is striking utensils.
Utensils not arranged correctly.