Siemens 9000407137(8811) manual Water softening system, Selecting language, Language Setting

en

Selecting language

The language in the display window 12

can be set from				to			. ªDeutschº
is the factory setting.
Language							Setting
Deutsch									L:01
English									L:02
Français									L:03
Nederlands									L:04
Italiano									L:05
ÅËËÇÍÉÊÁ									L:06
Español									L:07
Português									L:08
Svenska									L:09
Norsk									L:10
Suomi									L:11
Dansk									L:12
Türkçe									L:13
PYCCŽÅœ									L:14
Polski									L:15
Èeš.									L:16
Magyar									L:17
Croatian									L:18
Slovenian									L:19
To change the language:
Open the door.
Switch on ON/OFF switch									.
							1
Hold down programme button
									A
and press START button									until the
							10
digital display					is indicated.
			3
Release both buttons.
Press programme button									until
							A
the factory set value							is indicated
on the digital display						.
					3
ªDeutschº is indicated in the display
window		.
	12
Press programme button								.
							C

Each time the button is pressed,
the set value increases by 1; after
, the setting goes back to			.
Press START button		.
	10
The set value is saved.
Close the door.

Water softening system

To ensure good washing results, the dishwasher requires soft water, i.e. containing low amounts of lime, otherwise white limescale will be deposited on the utensils and inner container.

Tap water above 7_ dH (from set value

) must be softened.

The water is softened with salt (regeneration salt) in the water softening system of the dishwasher.

The setting and therefore the required amount of salt depends on the degree of hardness of your tap water (see table).

Set

The amount of salt dispensed can be set

from	to	.
Sal is not required at the set value			.

Find out about the hardness value of your tap water. Your water supply company will assist you.

Set value can be found in the water hardness table.

Open the door.
Switch on ON/OFF switch		.
	1
Hold down programme button
		A
and press START button		until on
	10
the digital display is indicated		.

Release both buttons.

The LED for button A flashes and the digital display displays the factory

setting .

To change the setting,

press programme button C .

Each time the button is pressed, the set value increases by one level; when the

value of	has been reached,
the display jumps back to		(off).

Press START button 10 .

The chosen setting has now been stored.

Close the door.

6