Siemens MTX-H15 user manual Data, Hsdpa, Umts

MTX-H15 UMTS-HSDPA terminal modem http://www.matrix.es

1.3.4 Data

The wireless modem supports the following data protocols:

•HSDPA:

3.6Mbps DL / 384 kbps UL

•UMTS

384 kbps DL / 384 kbps UL

•GPRS (General Packet Radio Service)

The wireless modem is a Class B terminal, multislot class 10.

•EGPRS

Multislot Class 10

•CSD (Circuit Switched Data)

9.6kbps

1.3.6 OPERATION MODES

The table below briefly summarizes the various operating modes referred to in the following chapters.

Mode	Function
		Power saving mode set automatically when no call is in progress and the
Normal	GSM / GPRS / UMTS /
operation	HSDPA SLEEP	USB connection is suspended by host or not present.
		Software is active. Once registered to the GSM network, paging with BTS is
	GSM IDLE
		carried out in order to achieve synchrony with the GSM network. The
		repetition rate depends on the parameter BSPA_Multiframe. The module is
		ready to send and receive.
		Connection between two subscribers is in progress. Power consumption
	GSM TALK/ GSM DATA
		depends on the GSM network coverage and several connection settings
		(e.g. DTX off/on, FR/EFR/HR, hopping sequences and antenna connection).
		The following applies when power is to be measured in TALK_GSM mode:
		DTX off, FR and no frequency hopping, otherwise same as for IDLE
		measurements.
		Module is attached and ready for GPRS data transfer, but no data is
	GPRS IDLE
		currently sent or received.
		GPRS data transfer in progress. Power consumption depends on net-work
	GPRS DATA
		settings (e.g. power control level), uplink / downlink data rates and GPRS
		configuration (e.g. used multislot settings).
		EGPRS data transfer in progress. Power consumption depends on net-work
	EGPRS DATA
		settings (e.g. power control level), uplink / downlink data rates and EGPRS
		configuration (e.g. used multislot settings).
		Module is attached and ready for UMTS / HSDPA data transfer, but no data
	UMTS / HSDPA IDLE
		is currently sent or received.
		UMTS data transfer in progress. Power consumption depends on net-work
	UMTS TALK/ UMTS
	DATA	settings (e.g. TPC Pattern) and data transfer rate.
		HSDPA data transfer in progress. Power consumption depends on net-work
	HSDPA DATA
		settings (e.g. TPC Pattern) and data transfer rate.
		is shut down. The SW on the module is not active. The interfaces are not
Power	The internal power section
Down	accessible.

Average power consumption

MTX-H15 User Manual V.2.0Pag. 9

Preliminary. Subject to change without prior notice