Appendix

Restoring the handset default settings

You can reset any individual settings and changes that you have made. Entries in the directory, the call-by-call list, the calls list, the SMS lists (depending on base sta- tion) and the handset's registration to the base station as well as the content of My stuff are retained.

w¢Ð¢Handset ¢Reset Handset

Yes

Press the display key.

aPress and hold (idle status).

Appendix

Care

¤Wipe the charging cradle and the hand- set with a damp cloth (do not use sol- vent) or an antistatic cloth.

Never use a dry cloth. This can cause static.

Contact with liquid !

If the handset has come into contact with liquid:

1.Switch off the handset and remove the battery pack immediately.

2.Allow the liquid to drain from the hand- set.

3.Pat all parts dry, then place the handset with the battery compartment open and the keypad facing down in a dry, warm place for at least 72 hours (not in a microwave, oven etc.).

4.Do not switch on the handset again until it is completely dry.

When it has fully dried out, you will normally be able to use it again.

Questions and answers

If you have any questions about using your handset, visit us at any time at www.siemens.com/gigasetcustomercare. The table below contains a list of common problems and possible solutions.

The display is blank.

1. The¥ handset is not switched on.

Press and hold the end call key a.

2.The¥ battery pack is flat. Charge/replace the battery pack (page 5).

The handset does not respond to a key press.

The¥ keypad lock is activated.

Press and hold the hash key #(page 8).

"Base station x" is flashing in the display.

1. The handset is outside the range of the base station¥ .

Reduce the distance between handset/ base station.

2. The¥ handset has been de-registered. Register the handset (page 6).

3. The¥ base station is not switched on. Check the base station mains adapter.

Base Search is flashing in the display.

The handset is set for Best Base and no base station ¥ is switched on or within range.

Reduce the distance between handset/base

¥station.

Check the base station mains adapter.

Handset does not ring.

The¥ ringtone is switched off.

Activate the ringtone (page 18).

The other party cannot hear you.

You have pressed the u(INT) key. The handset ¥ is "muted".

Switch on the microphone again (page 8).

You hear an error tone when keying an input

(a descending sequence of tones).

Action¥ has failed/invalid input. Repeat the operation.

Watch the display and refer to the instructions if necessary.

22