Setting up the handset for use

Fitting the battery pack

Caution:

Only use the rechargeable Siemens original battery pack (page 23)! This means that you should never use a conventional (non- rechargeable) battery pack, as this may cause significant damage to health and property. For example, the outer casing of the battery pack could be destroyed or the battery pack could explode. The phone could also malfunction or be damaged as a result of using batteries that are not of the recommended type.

¤With the pins to the front, insert the battery pack into the cavity at an angle from the right.

¤Then press it into the housing from above until the bracket on the side of the battery back snaps securely into the housing.

Please note:

To remove the battery pack, you must first press the bracket on the side.

Closing the battery cover

¤First, align the notches on the side of the battery cover with the protrusions on the inside of the housing.

First Steps

¤Then press the cover until it clicks into place.

Attaching the belt clip

There are notches for attaching the belt clip on the side of the handset at the same height as the display.

¤Press the belt clip onto the back of the handset so that the protrusions on the belt clip engage with the notches.

Opening the battery cover

¤If fitted, remove the belt clip.

¤Lift the device with the keypad in the palm of your hand.

¤Insert your index finger into the notch on the lower edge.

¤Carefully lift the cover upwards out of the notches.

5