Pressure Setting
If set to Manual Setting
Press the 
button in the Measurement mode to display set values. “P_1” or “n_1” and the current set value will flicker alternately.
Press the 
button to display the next set value.
Press the 
or 
button to enter into the Value Change mode. (See “Value Setting”)
If Hysteresis mode is set
If the Hysteresis mode is set, “H” and the set value of Hystersis will be displayed alternately after the setting for “P_1”.
Press the 
button to return to the normal Measurement mode.
Press the 
or 
button to enter into the Value Change mode. (See “Value Setting)
In case Hysteresis is set at less than or equal to 2 digits, switch output may chatter if input pressure fluctuates near the set point.
If window comparator mode is set
If the Window comparator mode is set, “P_2” or “n_2” and the current set value will be displayed alternately after the setting for “P_1”.
Press the 
button to display the next set value. (Hysteresis : H) Press the 
or 
button to enter into the Value Change mode. (See “Value Setting”)
Next, “H” and the set value of Hysteresis will be displayed alternately.
Press the | button to return to the normal Measurement mode. | |
Press the | or | button to enter into the Value Change mode. |
(See “Value Setting”) |
| |
If the initialize value is the Normally Open mode, “P_1” will be displayed. “n_1” will be displayed if it is Normally Closed mode. The set pressure value can be checked without holding or stopping switch output operation.