Sigma KS-342 manual Right side viewed from front

KS-342

The routing switch sends the aux signal to the L and R main out- put busses (AUX MIX) or to the monitor bus only (AUX MONI) or completely off (center position).

Right side (viewed from front)

This section is chiefly the outputs from the mixer:

����	��������
	��������
������������� ������
�������	������
	�����

					������	������		�������
					���			����������������
		�����		���		������		� �� � ���
						���		� ��� � ����������
		�					�����	�����������������
���			�	���				�����������������
�� � ���	�	��� �� � �		�� � ���		������	���
	�������			���		���	���

����������������	�������	��������
	�������
��������		������
�������������������	������
	�����������
	�����

MAIN outputs L and R Balanced XLR-3 connectors providing the main analog output signals from the KS-342. They can also be used to provide the outputs from input channels 1 and 2, for example when these are used in MS mode.

MAIN level controls Use these rotary controls to adjust the level of the signals sent from the main outputs.

MAIN compressor controls The main output busses can be compressed using the onboard compressor (this applies to all outputs fed by the output busses. The triggering of the compressor can be done by either the L or the R bus, or ST LINK setting, in which either bus can be above the trigger level, or L•R in which both busses must be above the trigger level (the off position is represented by the • symbol). The trigger level itself can be set to +3 dB (3), +6 dB (6), +9 dB (9) or +12 dB (12).

SUB output This XLR-5 connector provides the main output busses as balanced sub outputs (or this connector can also be

10