11
KS-342
used as direct outputs from channels 3 and 4) . The wiring is:
1 = ground, 2=L+, 3 = L–, 4=R+, 5=R–. There is a choice of output
levels: –20 dB or –60 dB, selectable by the sw itch immediately
below this connector.
ST OUT Th is unbalanced 3.5 mm stereo jack output provides
another stereo output for feeding unba lanced inputs ( on a
camera, for example). The level is –60 dB.
SOURCE SELECT switch This allows the choice of whether
the MAIN and SUB connectors a bove output the mixed left and
right output busses (MIX) , or whether they output the individual
channels in pairs (D IRECT OUT).
AES/EBU The KS-342 is capable of outputting the stereo output
in AES/E BU format. The sampling freq uency is selectable with
the rotary switch beside t he XLR -3 outputs at either 44.1K,
48K or 96 K (all Hz). The • po sition represents the off position
(no digital signal is output).
NOTE
When this digital output is enabled, it uses battery power. If you
are not using it, make sure that the switch is in the off position,
to extend the life of the batteries.
DC IN Use this to connect a DC power supply, providing between
+10 V and +15 V at no more than 600 mA. Wire the connector as
marked on the panel.