MAINTENANCE INSTRUCTIONS
7Remove the front plate containing the outlet port mechanism from the empty Model 880 device by removing the four
After removing the outlet port mechanism, clean the ‘S’ tube of the exposure device by pushing cloth swabs wetted with solvent through the ‘S’ tube until they come out clean. Use a dry cloth swab to remove any residual solvent from the ‘S’ tube after cleaning.
Clean the exterior of the Model 880 using a mild detergent solution to remove all dirt and grime. Visually inspect the exposure device’s stainless steel end plates for weld failures (cracks, etc.) on the locking mechanism and outlet port ends. Ensure the handle, the bottom contact surfaces and sides comprising the plastic jacket are intact. Check the bottom surfaces of the jacket to ensure the contact area is not excessively worn allowing contact of the stainless steel body with a flat work surface. Additionally, if dents to the device’s body or flanges due to accidental drops are found during this inspection, these repairs must be performed at a QSA Global service center.
Ensure that all of the information contained on the Model 880 label is legible. The trefoil and the warning, ‘Caution or Danger, Radioactive Material’, must be legible at a distance of 3 ft (approximately 1 m). The model number, serial number and Type B certification number (or Type A Specification identification) must also be legible. For label replacement, remove the old label from the exposure device by using a number 30
Disassemble the front plate (outlet port mechanism) by removing the set screw (or roll pin) from the outlet port cover. Unscrew the two socket head cap screws from the pivot disk. Remove and discard the two compression springs from the outlet port mechanism and replace with new springs.
Clean all parts in solvent using a brush to dislodge all dust and dirt. Dry all components thoroughly. Do not lubricate, leave all components completely dry.
Inspect for wear and burrs on the brass slider and rotor surfaces. Verify the tungsten port shield is not loose within the rotor. If the port shield is loose, remove the set screw, apply VibratiteTM thread sealant and retighten the set screw against the tungsten port shield. If the port shield uses a roll pin, remove the roll pin and replace. Inspect the front plate’s outlet port for wear and burrs where the source guide tube bayonet fitting engages.
Install new compression springs and assemble the outlet port mechanism. Apply VibratiteTM thread sealant to the socket head cap screws before tightening. Install a new set screw to the outlet port cover.
After assembly of the front plate, perform the following safety function tests using a bayonet source guide tube fitting. Pull the outlet port cover and rotate clockwise 90 degrees. Movement should be smooth and limited to a clockwise 90 degree turn. Insert a bayonet fitting into the outlet port and rotate 90 degrees in a
4.9