SIIG 04-0568A manual

The Limited Warranty does not cover Connected Equipment, but as is explained below, to be covered under the Connected Equipment Guarantee, the Connected Equipment must have been damaged due only to a direct failure of the Product. The Connected Equipment must have been damaged due to only a defect in materials or workmanship of the Product.

In the event of damage to the Connected Equipment, your exclusive remedies, and SIIG’s sole obligations, are as follows for Connected Equipment. If (a) the Product purchased and owned by you is defective in material or workmanship: (b) the Limited Warranty requirements havebeenmet,and;(c)noneofthelimitationsorexclusions on warranty coverage apply, SIIG will (as SIIG elects, as permitted by law), repair, replace, or pay the Agreed Damage Amount (defined below) for, the item(s) of your electronic equipment directly and properly connected to the product (the “Connected Equipment”) if that Connected Equipment is (x) damaged by AC power line transients, spikes, or surges on properly installed, grounded, and code-compliant 120 volt power lines in the United States and Canada, or by transients, surges or spikes on standard telephone equipment lines, or Base 10/100T Ethernet lines that are properly installed and connected (a “Power Disturbance”) and (y) is directly plugged into and properly connected to a SIIG product in its original condition which is properly operated when a Power Disturbance passes through the SIIG Product and (z.1) exhausts the protection capacity of the SIIG Product or (z.2) damages the SIIG Product. This provision sets out the only liability of any character of SIIG for direct, indirect, special, consequential, and/or incidental damages only to Connected Equipment, and all such Liability is limited to the Agreed Damage Amount.

10