ToolStick Debug Adapter
4. Hardware Setup using a ToolStick Debug Adapter
Configure the ToolStick Debug Adapter
1.Place the jumper J1 in the appropriate position for the I/O voltage of the Target Board being used. Connect pins 1 and 2 (VREG and VIO) for 2.5 V I/O or connect pins 2 and 3 (VDD and VIO) for 3.3 V I/O.
2.If the Target Board will be powered from the ToolStick Debug Adapter, place a jumper on header J2. If the Target Board will be separately powered, ensure that no jumper is installed on header J2.
Note: Powering the Target Board from the ToolStick Debug Adapter and a separate power supply at the same time could cause damage to the ToolStick Base Adapter and/or the Target Board.
J3
P2
J1
J2
Figure 4. ToolStick Debug Adapter Jumpers
Connect the ToolStick Debug Adapter to the Target Board as shown in Figure 5.
1.If not already assembled, insert the ToolStick Debug Adapter into a ToolStick Base Adapter.
2.Connect the
3.Connect one end of the USB cable to the USB connector on the ToolStick Debug Adapter.
4.Connect the other end of the USB cable to a USB port on the PC that will run the Silicon Laboratories IDE.
5.Connect the AC/DC power adapter to the power jack on the target board, or configure the board to receive power from the ToolStick Debug Adapter (see the Target Board Kit User’s Guide for configuration options).
Notes:
Use the Reset button in the IDE to reset the target when connected using a ToolStick Debug Adapter.
Remove power from the target board and the ToolStick Debug Adapter before connecting or disconnecting the ribbon cable from the target board. Connecting or disconnecting the cable when the devices have power can damage the device and/or the ToolStick Debug Adapter.
ToolStick | Debug |
Base Adapter | Adapter |
Target Board
Figure 5. Hardware Setup Using a ToolStick Debug Adapter
Rev. 0.1 | 3 |
