Silvercrest D-44867 operating instructions Connection

Connection Operating the Indoor Antenna

➭Place the device on a firm and level surface.

Connection to a television

➭Connect the antenna cable of the indoor anten- na 6 to the antenna socket of your television. The antenna cable of the indoor antenna 6 can only be connected directly to the TV if the TV has a built-in DVB-T Tuner.

Connection as a radio aerial

➭When you want to use the room antenna for radio reception, utilise the Adapter Coaxial socket/Coaxial socket 8.

➭Connect the Adapter Coaxial socket/Coaxial socket 8 with the antenna cable.

➭Connect the anntenna cable with Adapter Coaxial socket/Coaxial socket 8 to the 75 Ohm connector on your stereo system.

Connection to a DVB-T receiver

➭Connect the antenna cable of the indoor antenna 6 to the antenna socket of the DVB-T Receiver.

➭To connect the room antenna to a DVB-T- Receiver with an F-socket, the Adapter F-Plug/ Coaxial socket 7 must be used.

➭Connect the Adapter F-Plug/Coaxial socket 7 with the antenna cable.

➭Screw the antenna cable with the Adapter F-Plug/Coaxial socket 7 to the F-socket of the DVB-T-Receivers.

Power source connection

➭Insert the power plug of the indoor antenna into the power socket.

Receiving programme signals via the indoor antenna

The programme signals are received by the indoor antenna and transmitted to the television set.

For the reception of DVB-T transmitter signals you need a TV with an integrated DVB-T Tuner or an additional DVB-T Receiver (DVB-T signals are not available everywhere).

The indoor antenna has to be positioned correctly for the proper reception of programme signals. The following antennas are available for this:

1two telescoping antennas for VHF and UKW reception that tilt and rotate by 180° and

2one oval-shaped antenna for UHF reception that tilts and rotates by 100°.

To orient the indoor antenna:

➭Pull out both telescopic antenna 1

➭and adjust these until the best reception is obtained.

➭Adjust the oval antenna 2 by turning or tilting until the best reception is obtained.

Switching On and Regulating the Amplifier

You can regulate the amplifier gain by turning the regulator 4 on the front of the appliance:

➭Switch on the indoor antenna by turning the regulator 4 to the right. The operation indicator 3 glows green.

➭Turn the regulator 4 in clockwise direction to increase the amplifier gain.

➭Turn the regulator 4 in anti-clockwise direction to decrease the amplifier gain.

➭Turn the regulator 4 completely to the left until it clicks to switch off the indoor antenna.

- 4 -