Silvercrest SAS 150 A1 Safety / Before the First Usage / Operation, First steps, Working advice

Safety / Before the First Usage / Operation

Use the appliance with the supplied accesso- ries only. No claims under the warranty nor a liability for damages will be accepted if they re- sult from improper or incorrect use of the slicer.

Place the catch tray 17 below the support table 9 and on the housing such that the sliced foods can fall in there directly and with- out hindrance after being cut.

Before the First Usage

First steps

Carefully remove the electric Multi-Purpose Slicer from its packaging, remove all packag- ing materials and keep them together with the main packaging.

Clean the electric Multi-Purpose Slicer before it comes into contact with any foodstuffs (see also the chapter ‘Cleaning’).

Setting up the appliance

Specific safety advice on the placing of the appliance

1.Never set the electric Multi-Purpose Slicer up on a hot surface or near an open flame.

2.Ensure that the power cable 8 does not pass over hot or sharp-edged objects.

3.Do not allow the power cable 8 to become kinked or trapped and do not wrap it around the electric Multi-Purpose Slicer.

Set the electric Multi-Purpose Slicer up on a flat, non-slip surface close to a power socket. Unwind the required length of power cable 8 . Insert the plug into the power socket.

Place the food carriage 10 on the supporting table with guide slot 9 (see Fig. B). Now press the on the blade cover 6 high standing side down, so that the holding clamps (on the underside of the food carriage 10 ) engage. En- sure that these have correctly engaged, in that you check the mobility of the food carriage. Pull to the front for removal of the food carriage 10 from the guide slot 9 and lift it from the sup- port table 9 .

Push the food holder plate 11 on to the food carriage 10 .

Adjust the infinite slice-thick- ness setting (see Fig. D)

Through variable tightenings of the adjusting screws 16 you can determine the movement rate of the infinite slice-thickness setting 14 .

Screw both of the adjusting screws 16 tight with the screwdriver 15 .

Check, by turning the infinite slice-thickness control knob 14 , to see if the desired movement rate is suitable.

If it is not,

-loosen both adjusting screws 16 for a lighter movement rate or

-tighten both adjusting screws 16 further for a stiffer movement rate.

Operation

Working advice

Specific safety advice for slicing and for the handling of the appliance

1.Never touch the cuttingblade 12 when the slic- er is in operation!

There is a risk of grave personal injury!

2.Always use the food carriage 10 and the food holder plate 11 .

(Exception: very large pieces of foodstuff). Press the pieces of food to be sliced forward using the food holder 11 .

3.Use the slicer only for cutting normal house- hold foods and not for other purposes. Do not use the slicer for cutting deep-frozen foods, bones, foods with large kernels or for the slicing of still packaged foods.

4.Never use the slicer continuously for more than 10 minutes .

8

GB/IE