Silvercrest SAS 150 A1 manual Cleaning and maintenance, Special accessories

Cleaning and maintenance

Cleaning and maintenance

Cleaning

Important safety advice for cleaning the slicer

1.Before starting to clean the electric Multi-Pur- pose Slicer; switch it off, remove the power ca- ble 8 from the mains socket and set the food support plate 13 into the „0“ setting.

2.Do not submerse the electric Multi-Purpose Slicer in water.

3. ATTENTION! RISK OF SERIOUS INJURY: The cutting blade 12 is very sharp!

Accessories suitable for dishwashers!

Clean the food carriage 10 , the food holder plate 11 , the cutting blade 12 and the slice tray 17 in the dishwasher.

It is necessary to clean the electric Multi-Pur- pose Slicer thoroughly at regular intervals as perishable food scraps could accumulate on the appliance or behind the cutting blade 12 . Clean all appliance parts not suitable for the dishwasher with a lightly moistened cloth. Wipe off the appliance housing 5 , the cutting blade covering 6 , the support table with guide slots 9 and the food support plate 13 carefully. Do not use abrasive cleaning agents, sponges with rough surfaces or hard brushes.

Cleaning brush:

ATTENTION! RISK OF PERSONAL INJU- RY! Carry out all tasks using the cleaning brush

19(see Fig. F) with great care. Should it slip close to the cutting blade 12 , there is the risk of receiving a severe personal injury.

Use the bristles of the cleaning brush 19 to re- move remnants such as crumbs from all difficult to reach positions. The flattened end can be excellently used to remove stubborn soiling.

Maintenance / Removing / assembling the cutting blade

Important safety notices for the removal and assembly of the cutting blade!

1.Switch the slicer off, remove the plug from the power socket and set the food support plate 13 into position „0“.

2. ATTENTION! RISK OF PERSONAL INJURY! The cutting blade 12 is very sharp! For the removal and assembly wear appropriate safety gloves. Otherwise, you could receive cut injuries.

Open the blade cover 6 by pressing the blade cover unlock button 4 . Remove the blade cover 6 .

Remove the plastic screw clip 18 from the mounting (see Fig. E) and screw the blade lock of the cutting blade 12 out by unscrewing it to the left.

When taking out the blade 12 make sure that you grasp it at its centre.

The cutting blade 12 can be cleaned in the dishwasher.

Clean the housing behind the cuttingblade 12 with a dry cloth or a soft brush.

Re-assemble the cutting blade 12 in a reverse sequence of the above instructions.

Due to the special sawtoothing and the high quality, the cutting blade 12 will retain its sharpness for a very long time. A resharpening of the cutting blade is not necessary. Consult the service centre for your country if you have questions about the cutting blade 12 .

Special accessories

Round cutter:

An untoothed cutting blade, specifically for the finest of slices, is also available.

Orders for special accessories are be directed to the service centre for your country.

10 GB/IE