15 CHANGING THE QUANTITY OF COFFEE AND MILK FOR LATTE / CAPPUCCINO / ITALIAN MACCHIATO
The appliance is factory preset to automatically deliver standard quantities of coffee or milk. To change these quantities, proceed as follows:
•Fill the container with milk up to the maximum level indicated on the container.
•Press the button corresponding to the preparation you want to change (LATTE/ CAPPUCCINO / ITALIAN MACCHIATO) for at least 8 seconds until the appliance emits a BEEP and displays:
MILKFOR PROGRAMQUANTITY
Then release the button. The appliance starts delivering milk.
•Once the required quantity of milk has been delivered, press the button selected previously again. Milk delivery stops and the quantity is memorized. (The appliance emits a BEEP.)
•After a few seconds, the appliance delivers coffee into the cup and displays:
COFFEEFOR .PROGRAMQUANTITY
•Once the required quantity of coffee has been delivered, press the button selected previously again. Coffee delivery stops and the quantity is memorized. A double BEEP confirms that the new values have been memorized.
The appliance is now
16 CLEANING AND MAINTENANCE
Before performing any cleaning operations, leave the appliance to cool down and unplug from the outlet. Never immerse the coffee maker in water. It is an electrical appliance.
Do not use solvents, abrasive cleaning products or alcohol to clean the appliance. A soft damp cloth will suf- fice.
No component may be washed in the dishwasher.
16.1 Cleaning the coffee maker
Clean the grounds container (as described in section 6, note 7) whenever it requires emptying. The water tank should also be cleaned regularly.
The drip tray is fitted with a level indicator (red) showing the level of water it contains.
When the indicator starts to become visible (a few millimeters under the drip tray), the drip tray must be emp- tied and cleaned.
Check that the holes in the coffee spout are not blocked.
To unblock them, scrape the dry coffee residues away with a needle (fig. 29). Clean the nozzle after every use with a sponge as shown in fig. 30.
16.2 Cleaning the infuser
The infuser must be cleaned regularly to avoid the
•Turn the appliance off by pressing the 
button (fig. 6) (do not unplug) and wait for the display to go off.
•Open the service door (fig. 13).
•Remove the drip tray and the grounds container (fig. 14) and clean.
•Press the two red release buttons on the infuser and pull it out (fig. 31).
•IMPORTANT:THE INFUSER CAN ONLY BE REMOVED WHEN THE APPLIANCE IS OFF. ATTEMPTING TO REMOVE THE INFUSER WITH THE APPLIANCE ON MAY CAUSE SERIOUS DAMAGE.
•Wash the infuser under running water, without using detergents. Never wash the infuser in the dishwash- er.
•Clean the inside of the appliance thoroughly. To remove coffee encrustations from the inside of the appli- ance, scrape with a plastic or wooden fork then vacuum up the residues with a vacuum cleaner (fig. 32).
•Replace the infuser by sliding it onto the supports and pin at the bottom, then push the PUSH symbol fully in until it clicks into place.
| 15 |
|
C o l l e c t i o n |
| |
|
|
|
