DeLonghi ESAM6600 manual HOT Water Program Quantity, Cappuccino Container Pointer in Position

NOTE 4: Use ground coffee for espresso coffee makers only. Do not use coffee beans, freeze-dried coffee or other materials that could damage the appliance.

NOTE 5: If you add more than one measure of ground coffee and the funnel blocks, use a knife to push the cof- fee down (fig. 16), then remove and clean the infuser and appliance as described in section 16.2 "Cleaning the infuser".

10 PRODUCING HOT WATER

•Always make sure the appliance is ready.

•Make sure the water spout is attached to the nozzle (fig. 4).

•Position a container under the spout (fig. 3).

•Press the button (fig. 17).

The appliance displays:

HOT WATER

and hot water is delivered from the water spout into the container below (you should not run off hot water

for more than two minutes at a time). To stop the flow, press the button. Once the set quantity of hot water has been reached, delivery stops automatically.

11 CHANGING THE QUANTITY OF HOT WATER

The appliance is factory preset to automatically deliver 8.5 oz. of hot water. To change this quantity, proceed as follows:

•Make sure the water spout is attached (fig. 4).

•Position a container under the spout (fig. 3).

• Press the	button (fig. 17) for at least 8 seconds until you hear a BEEP, then release. The appliance dis-
plays:

HOT WATER PROGRAM QUANTITY

and hot water is delivered from the water spout.

•When the hot water in the cup reaches the required level, press the button to memorize the new amount. The appliance emits a double beep. (You should not run off hot water for more than two minutes at a time).

12 PREPARING CAPPUCCINOS (FROTHED MILK AND COFFEE)

•Select the required coffee strength to make the cappuccino by pressing the OK/ button (fig. 1).

•Remove the frothed milk lid from the milk container.

•Fill the container with about 3.5 oz. of milk for each cappuccino to be prepared (fig. 18). Never exceed the MAX level (corresponding to about 25 oz.) marked on the container.

It is best to use fat-free or low-fat milk at refrigerator temperature (about 41°F/5°C).

•Make sure the milk intake tube is correctly inserted in the rubber washer on the bottom of the milk con- tainer lid (fig. 19), then reposition the lid in the milk container and turn it counter-clockwise as far as it will go.

•Move the pointer on the milk container to position 2 (fig. 20).

•Remove the hot water spout (fig. 21) and attach the milk container to the nozzle. You will hear a BEEP (fig. 22).

•Position the milk tube as shown in fig. 23 and then place a sufficiently large cup under the coffee and milk spouts.

•Press the CAPPUCCINO button (fig. 24). The button lights up and the appliance displays:

CAPPUCCINO: CONTAINER POINTER IN POSITION 2

Make sure the pointer on the container lid is positioned on the same number indicated on the display. After a few seconds, the frothed milk is delivered from the milk spout into the cup below. Milk delivery stops automatically, then the coffee is delivered.

	13
C o l l e c t i o n