Sim2 Multimedia HT 300E, HT 280E installation manual T 3.15A H Fig

Please follow carefully the warnings listed below, to ensure safe and long term performance of your projector.

•Connect the projector to a power supply with a nominal voltage within the following values: 100-240 Vac, 50/60 Hz, earthed (Fig. 3).

								romettre
					pour ne		pas compd'incende
							resque		type
						les		de meme
	ATTENTION:contrefusible								against
	la protectionpar un
	remplacer				caracteristiqueprotection
	et	de mems
				for continued
	CAUTION:replace
	risk of		fire,			type
				same
	only with			fuse.
	and rating						AUDIO
3		5	DIGITAL					OUT
			INPUT

100-240 Vac

50/60 Hz

Fig. 3

•The mains plug is the disconnect device. Take care, when installing, that the mains plug and socket outlet are easily accessible. Never pull on the cable to take it out of the socket. If the system is unlikely to be used for a number of days, disconnect the power cable and other apparatus connected to it.

•To save energy, switch off the projector by using the power switch at the rear; when in stand-by (red light on) the projector continues to draw a minimal amount of power.

•Only replace the safety fuse (on the power socket at the rear of projector) with a fuse identical in type and characteristics

(T 3.15A H) (Fig. 4).

• Do not use the projector when the room temperature is above

35°C (95°F).

• Do not obstruct the cooling air inlets on the top cover, or the

air outlets underneath the projector.

• Do not switch on the projector if it is standing on soft sur-

faces such as cushions, pillows, blankets, mattresses and

carpets: the air cooling outlets underneath could become

obstructed.

• Do not switch-on the projector if it is standing on surfaces

sensitive to heat, as this may result in damage caused by

the hot air outlets underneath. Should this be unavoidable

take extra precaution of protecting the surfaces with a layer

of heat resistant material.

• Intense Light Source! Do not stare directly into the projection

lens as possible eye damage could result. Be especially

careful that children do not stare directly into the beam.

• Do not open the projector’s cover; no user serviceable parts

are inside. Refer servicing to qualified service personnel.

Opening the projector’s cover will invalidate warranty.

• Take care not to shake the projector whilst carrying it by the

handle.

• Always position the projector away from direct heat sour-

ces.

• Do not touch the surface of the projection lens.

• The projector must be positioned on a stable, suitable pla-

tform or be installed using a bracket for fixed ceiling or wall

installation. Do not rest the projector on the side panels or

pas		compromettre
				d'incende
resque					type
le de			meme
ique					against
ed	protection

1

AUDIO OUT

2

4

250 V

T 3.15A H

3

on the rear panel when in operation.

• Take care to position cables safely, especially in dark places,

in order to avoid a trip hazard.

• For installations using a ceiling or wall-mounted bracket, ca-

refully follow the installation and safety instructions provided

with the bracket’s literature.

Fig. 4

•Do not switch on your projector when flammable liquids or fumes are present. Do not pour or drop fluids in the vents.

• Please remove batteries from the remote control if not in use

for a long period of time.

5