Sim2 Multimedia HT 300E, HT 280E Switching On And Off The Projector, Switch On From Stand-By

Avoid light shining directly on the screen during projection as this will reduce contrast and black level detail on the projected image. For the true cinema experience best results are achie- ved with little or no ambient light.

Furniture and other objects with reflecting surfaces, as well as light coloured walls should be avoided, as they are likely to interfere with the screen’s characteristics.

5 SWITCHING ON AND OFF THE PROJECTOR

CAUTION: Connect the projector to a power supply with a nominal voltage within the following values: 100-240 Vac, 50/60 Hz. It must be earthed (Fig. 13).

���������������

����������������

������������

������������

�������

����������

Fig. 13

Upon switch on (in position I) the projector will initialise (red and green LEDs on). Followed by stand-by mode (red LED on) (Fig. 14).

ne pas

compromettre

pour

d'incende

resque

type

contre les

de meme

ATTENTION:

fusible

against

la protectionpar un

remplacer

caracteristiqueprotection

et

de mems

for continued

CAUTION:replace

R/Cr

risk

of fire,

type

with

same

.

only

fuse

and rating

AUDIO

RGB

G/Y

3

5

HDMI

OUT

ZOOM

4

GRAPHICS

B/Cb

2

(RS

232)

CONTROL

HV

Fig. 14

SWITCH ON FROM STAND-BY

By remote control: press one of 1...9

By keyboard: press Up or Down Arrow.

	ZOOM	4	GRA
	2
1		CONTRO
��
��

��

�

Fig. 15

When switching on from stand-by, the projector will turn on the lamp; after a brief warm up period the image will be displayed (green LED on).The input automatically selected will be the last one memorised prior to switch off (Fig. 15).

You may experience difficulties switching on the projector shortly after switching off: the lamp may fail to come on as it is too hot. Just wait a few minutes to cool it down.

9