Simplicity 1692149, 1692150 Initial Setup & Assembly, 30” MODELS BLADE AND ADAPTER ASSEMBLY

Initial Setup & Assembly

30” MODELS -

BLADE AND ADAPTER ASSEMBLY

Blade Assembly - 30” Mower

1.Remove the mower deck to access the blade or using an overhead hoist, elevate the front of the unit to access the mower blade.

2.Mount the lifts (B, Figure 6) to the discharge side of the blade as shown. Torque nuts to 14 ft. lbs.

Adapter & Mounting Hardware Installation - 30” Mower

1.Install reinforcement strap (A, figure 7) inside the adapter and secure it to the top outer holes using two 10-24 x 5/8" flat head screws (B), flat washers (C) and 10-24 nuts (D). Be sure the cut-off bracket (G) is installed between the reinforcement plate (A) and adapter.

2.In rear hole of mower deck, install 5/16-18 x 1-1/4 carriage bolt (E) from the bottom and secure with 5/16" jam nut (F).

	D
	C
	D
C	A
A
	F
	B
	E

Figure 7.

A.Reinforcement Plate

B.Flathead Screw, 10-1/4 x 5*8

C.Flat Washer

D.Nut

E.Carriage Bolt, 5/16-18 x 1-1/4

F.Jam But, 5/16-18

G.Cut-Off Bracket

8