Troubleshooting, Adjustments, & Service
Troubleshooting
ROLLER BAR LEVELING (SELECT MODELS)
The rollers on this Zero Turn unit are not intended to ride on the ground. DO NOT adjust rollers to ride on the ground. Rollers riding on the ground will damage turf and/or unit.
1.First level the mower deck using the procedure found in MOWER DECK LEVELING.
2.With the mower installed, place the rider on a smooth, level surface such as a concrete floor. Turn the front wheels so they are straight.
3.Place the mower cutting height pin in the 4th hole from the bottom (C, Figure 39).
4.Measure the distance between the outside ends of the roller bar and the ground. If there is more than 1/8” (3mm) difference between the measurements on each side, proceed to step 5.
5.Locate the roller bar leveling eccentric and locknuts (A, Figure 42). Loosen the locknut and turn the eccentric to raise or lower a side. When the correct level is achieved, hold the eccentric with a wrench and tighten the locknut. Repeat step 4 if necessary.
MOWER BELT REPLACEMENT
To avoid damaging belts, DO NOT
PRY BELTS OVER PULLEYS.
1.Park the rider on a smooth, level surface such as a concrete floor. Disengage the PTO, engage the parking brake, turn off the engine, and remove the ignition key.
2.Raise the mower deck to transport position. Pull the lever (A, Figure 42) towards the rear of the machine to release tension on the mower belt. Secure the lever in the guard notch (B).
3.Remove the old drive belt and install the new one as shown in Figure 43. Note that the back of the drive belt must ride against the
A |
Figure 41. Roller Bar Leveling
A. Eccentric and Locknut
B
A
Figure 42. Release Belt Tension
A.Belt Tension Release Lever
B.Guard Notch
A | C |
| |
B | A |
| |
A |
|
| D |
Figure 43. Mower Belt Routing
A.Arbor Pulleys
B.
C.PTO Pulley
D.Belt Tension Release Lever
38 | www.simplicitymfg.com www.snapper.com |
