Simplicity 2900 Series, 2000 Series RPM Rear PTO, Attach Mounting Plate A. Mounting Plate

Installation Instructions

2000 RPM Rear PTO

4.Attach the mounting plate (A, Figure 4) to the trans- mission using two socket-head capscrews (B) as shown. Torque capscrews to 60-65 ft. Ibs. DO NOT over-torque. Be sure the alignment pins and O-rings are facing toward the back of the tractor.

5.Grease the hydro pump output shaft with lithium grease .

Figure 4. Attach Mounting Plate

A. Mounting Plate

B. 112-13 x l-314 Socket Head Capscrews

6.Align the input shaft of the PTO box with the output shaft of the hydro pump and slide the PTO box into position (see Figure 5). Be sure to push the PTO box fully into position so that the alignment pins support the weight of the box; DO NOT allow the hydro pump output shaft to support the full weight of the PTO box.

7.Secure the PTO box to the mounting plate (A, Figure

5)using two 1/2-13x i-1/4 capscrews (B), lock wash- ers (C), and nylon locknuts (D).

8.Secure the PTO box to the transmission using one 1/2-13x i-3/4 capscrew (E, Figure 5) and lockwasher

(C). Torque to 60-65 ft. Ibs. DO NOT over-torque.

9.Remove the fill level plug (G, Figure 5) and oil fill plug (FL

iO.Add SAE 30 weight engine oil to the fill fitting until oil runs out of the fill level hole. The PTO box oil capaci- ty is approximately 16 oz (i/2 quart).

11. Reinstall the fill level and oil fill plugs.

Figure 5. Mount and Secure PTO Box

A. Mounting Plate

B. 1/2-13x t-114 Capscrew

C. Lo&washer

D. Locknut

E. l/2-13 x l-3/4 Capscrew

F. Fill Plug

G. Fill Level Plug

2