Operation
OPERATING THE SNOWTHROWER
1.Rotate the discharge chute to the desired direction.
2.Set the Speed Selector to the desired forward speed.
3.Fully press and hold the Auger Control (C, Figure 7) on the
4.Fully press and hold the traction Drive Control lever (B, Figure 7) on the
(B)will lock the auger control (C) in the engaged
position. Releasing the drive control (B) will release the auger control (C).
5.Select forward or reverse speeds as needed using the Speed Selector (A, Figure 7). Release the Drive Control lever whenever changing drive speeds.
NOTE: After 5 - 10 hours of use, it may be necessary to adjust the tension on the traction drive rod. See "Traction Drive Clutch Rod Adjustment" in the Service Section for the adjustment procedure.
GROUND SPEED SELECTOR
Use the Speed Selector (A, Figure 7) to control the drive speed of the snowthrower. There are five forward speeds and two reverse speeds.
Use the lower speeds to blow deep or wet snow. Use the higher speeds to blow light snow or to drive the snow- thrower without blowing snow.
To change speeds, first release the traction Drive Control lever (B, Figure 7), then move the Speed Selector to the desired speed setting. Fully press the traction Drive Control lever to resume operation.
ENGINE SPEED
Run the engine at full throttle when operating. Use the engine Throttle Lever (See Figure 8) to set the engine speed. Slide the Throttle Lever UP to increase engine speed, and DOWN to reduce speed.
C | A | D | B |
|
Figure 7. Operator's Control Position
A. | Speed Selector | C. | Auger Control |
B. | Drive Control | D. | Chute Direction Control |
Throttle |
Lever |
Throttle |
Lever |
Throttle |
Lever |
Figure 8. Engine Speed Selection
14
