Operation
Operating Without Collection System
WARNING
To operate without the collection system, the blower assembly must be removed and the deflector must be in down position.
1.Unhook the cart from the tractor by removing two cle- vis pins and spring clips (Figure 28).
2.To remove the blower, remove the belt from the pul- ley (A, Figure 31).
3.Close cover (D) and tighten knob.
4.Loosen wing nut (B) and, while holding deflector (C) up, pull blower off mover.
WARNING
The deflector is spring loaded. When removing the blower, hold the deflector up. Then allow the deflector to go down into normal operating posi- tion (see Figure 33).
5.Allow deflector to go down into position shown in Figure 32.
NOTE: For easier belt removal, later model blowers have a wire loop to move
Reinstallation After Removal
Raise the deflector to slide the blower into position. Tighten the wing nut (B, Figure 31). Place the belt onto the pulley (A) and close the cover (D) and tighten knob. Connect cart and chute.
Figure 31. Removing the Blower
A. | Pulley | C. Deflector |
B. | Wing Nut | D. Cover |
|
|
|
|
|
|
Figure 32. Deflector
14
