Figure 12. Install Support Tube
A.Support Tube
5.Install support tube (A, Figure 12) inside the box. Align each end of the support tube with the two holes at the front corner side of the box. Place one
COVER ASSEMBLY
1.Refer to Figure 13. Unfold the cover and spread it out on a flat, clean surface with the white dust shield side up. The two 3/8 inch rods are threaded through two sleeves inside the cover. The rod with the two bent ends is called the frame rod (B), since it lays on top of the box's frame. The rod with the two eyebolt ends is called the support rod, since it supports the top, rear side of the cover.
2.Thread the frame rod through the bottom sleeve of the cover so that the two bent ends protrude through the openings on each side. The openings (A) of the sleeve are found next to the black cord loops.
3.Thread the support rod (A, Figure 14) through the sleeve inside the cover.
4.Pick up the cover by holding the rods and place the support rod inside the frame rod before hooking the frame rod (A, Figure 19) through the eyelet of the support rod (B) on each end.
5.Place the cover assembly over the support tube. Insert the frame rod with the support rod attached through the hole in the support tube and secure with a flat washer (13/32 I.D., 7/8 O.D.) and safety clip (A, Figure 16) on each side.
Cover Assembly
Figure 13. Install Frame Rod
A. Opening | B. Frame Rod |
|
|
|
|
Figure 14. Install Support Rod
A. Support Rod
Figure 15. Connect Frame Rod and Support Rod
A. Frame Rod | B. Support Rod |
|
|
|
|
Figure 16. Secure Rods
A. Safety Clip
7
