Replacing Vacuum Bag and Filters
Replacing the vacuum bag
Change the vacuum bag when the full bag indicator light is flashing RED or suction power is weak. The bag compartment will not close without a bag in the unit or if the bag is not properly installed.
1. Open the bag compartment.
2. Pull the tab on the cardboard bag collar, which closes the bag while removing it from the bag holder.
3.Remove and discard the used bag.
NOTE: The HiFlow™ HEPA bag cannot be reused.
4.Slide a new bag into the bag holder until it clicks into place.
Replacing the secondary filter
1. Open the bag compartment and locate the filter behind the vacuum bag. For better access to the secondary filter, remove the bag.
2. Pull the filter holder up toward you.
3.Remove the used filter and replace it with a new filter.
4.Slide the filter holder back into place and replace the bag.
Replacing the HEPA filter
1. Push in and lift off the filter cover on the top of the vacuum.
2. Lift out the used HEPA filter and replace with a new filter.
NOTE: The HEPA filter cannot be washed and reused.
