156998841.qxp 12/13/2006 3:34 PM Page 18
Installation
WARNING!
Any electrical and/or plumbing work required to install this appliance should be carried out by a qualified electrician and/or plumber or competent person.
Water connection
WARNING!
This dishwasher may be fed with either hot (max. 60°) or cold water. Nevertheless we recommend connection to a cold water supply. When the dishwasher is likely to be connected to a solar hot water system, drip heater, or any other supply where temperatures in excess of 60° are anticipated, a water temperature tempering valve should be installed. A pressure reducing valve must be fitted if the hot water supply pressure can exceed 350 kPa or the cold supply pressure can exceed 800 kPa.
CAUTION!
WARNING!
Always use a new
If the machine is connected to new pipes or pipes which have not been used for a long time, you should run the water for a few minutes before connecting the inlet hose.
Inlet hose
Connect the inlet hose to a water tap with an external thread of 3/4” BSP.
The inlet hose can be turned either to the left or the right to suit the installation by means of the locknut.
The locknut must be correctly fitted to avoid water leaks.
Drain hose
-Connect drain hose to the sink. Secure it with the supplied hose clamp.
-Required height: 30 to 100 cm above bottom of the dishwasher.
-If you use a drain hose extension the total length should not be longer than 4 metres. Likewise the internal diameter of the couplings used for connections to the waste outlet must be no smaller than the diameter of the hose provided.
18
