•When replacing a fuse, use only a new one with the proper rating. Using a fuse with the wrong rating may cause the unit to malfunction.
•To prevent a short circuit when replacing a fuse, first disconnect the wiring harness.
Note
If the unit doesn’t seem to be working properly:
•Turn the unit’s power off, wait 5 – 10 seconds, then turn the power on again.
•If the unit still malfunctions, turn the unit’s power off, remove it from the cradle, wait 5 – 10 seconds, replace it in the cradle and turn the power back on. If the problem persists, contact Brix Technical Support at
FCC Warning
This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in this user guide. The user could lose the authority to operate this equipment if an unauthorized change or modification is made.
Note
This equipment has been tested and found to comply with Part 15 of the FCC Rules. These rules are designed to provide reasonable protection against harmful interference. This equipment may cause harmful interference to radio communications if it is not installed and used in accordance with these instructions. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and Streamer GT Receiver.
•Connect the equipment into an outlet on a circuit different from that to which the Streamer GT Receiver is connected
•Consult the dealer or an experienced radio/TV technician for help.
| 5 |
Streamer GT |
