3.Connect one end of the 3 ft.
4.Connect the other end of cable F to the Signal Combiner connector labeled DBS IN. When connected, be sure to slide the rubber boots on each end of the cable over the connections to protect the connections from the weather elements.
5.Connect one end of the 30 ft. RG- 58 cable (shown as E on page 3) to the SIRIUS outdoor antenna.
CABLE "E" CABLE "F"
COMBINER "A"
EXISTING
SATELLITE TV CABLE
"C"
SPLITTER "B"
6. Connect the other end of cable E |
|
|
|
to the Signal Combiner connector | CABLE "H" | CABLE "G" | SIRIUS |
labeled SIRIUS IN. When | RECVR/TUNER |
| RECEIVER |
|
| ||
connected, be sure to slide the |
|
|
|
rubber boots on each end of the |
|
|
|
cable over the connections to protect the connections from the weather elements.
Indoors:
1.Install the Signal Splitter (shown as B on page 3) near to where the cable which brings the signal from the satellite TV dish terminates. Use the provided screws for mounting.
2.Disconnect the cable which brings the signal from the satellite TV dish from the device that it is connected to (i.e., a Receiver/Tuner, or a Multiswitch, or a DishPro Adapter, etc.), and connect this cable to the Signal Splitter connector
labeled COMBINED IN. When disconnecting this cable, make a note of where it was connected for the next installation step.
3.Connect one end of the 10 ft.
4.Connect the other end of cable H to the Signal Splitter connector labeled DBS OUT.
SPLITTER
POWER DBS SIRIUS
IN OUT OUT
5.Connect one end of the 10 ft.
6.Connect the other end of cable G to your SIRIUS receiver.
10 | SIRIUS/DBS Signal Combiner/Splitter Installation Guide |