COMBINER 
SPLITTER
RECVR/TUNER
SIRIUS
RECEIVER
MULTISWITCH
RECVR/TUNERs
DISH NETWORK ONLY:
COMBINER 
SPLITTER 
MULTISWITCH
DISHPRO
ADAPTER
LEGACY RECVR/TUNER
RECVR/TUNERs
SIRIUS RECEIVER
Installation Procedure
Once you have determined where in your system you will be mounting the SIRIUS/DBS Signal Combiner/Splitter, you can proceed with the installation. If you have not yet mounted your SIRIUS outdoor antenna, do that first, carefully following the installation instructions included with the outdoor antenna. For ease of installation, mount the outdoor antenna on the support bracket for the satellite TV dish as shown in the antenna installation instructions, however, the SIRIUS antenna may be mounted anywhere within 30 feet of the satellite TV dish.
Once the SIRIUS outdoor antenna has been mounted, follow these steps to install the SIRIUS/DBS Signal Combiner/Splitter.
Outdoors:
1.Install the Signal Combiner (shown as A on page 3) in a convenient location within 3 feet of the satellite TV dish using the provided screws.
2.Disconnect the cable which brings the signal from the satellite TV dish and connect that cable to the Signal Combiner connector labeled COMBINED OUT.
COMBINED OUT
Depending upon where you are installing the SIRIUS/ DBS Signal Combiner/Splitter in your system, this cable may be connected to the LNBF at the satellite dish, or connected to a multiswitch, or connected to a signal splitter, etc. When disconnecting this cable, make a note of where it was connected for the next installation step.
COMBINER
DBS IN SIRIUS IN
SIRIUS/DBS Signal Combiner/Splitter Installation Guide | 9 |
