The laser light guide is a class IIIA laser with a maximum output power of 5.0m Watts and conforms to 21 CFR 1040.10 and 1040.11.
TO ADJUST THE LASER LINE GUIDE
Use a flat head screwdriver to turn the adjustment screw located on the side of the laser module (Fig. 4). Turn on the laser light guide by rotating the control wheel to setting number 2. Rotate the adjustment screw until the laser line is in the center of the blade. There is no need to turn the tool “ON” while adjusting the light beam.
The Laser line guide has a limited amount of travel. Do not continue to turn the adjustment screw after the line stops moving or if it becomes significantly harder to turn the screw. Overturning the adjustment screw may cause the adjustment system to break or cause the adjustment screw to fall out of the tool.
USING THE LASER LINE GUIDE
Only turn on the laser light on when the tool is on the workpiece.
1.First mark the line of cut on your workpiece (good side down.)
2.Insert plug into the power source.
3.Place the front edge of the saw foot on the workpiece, turn the 4 position contol wheel to setting 2 for laser light only or setting 3 for laser light and
4.Hold the tool firmly, squeeze the trigger and allow the tool to reach desired speed.
5.Press down (to keep the saw foot flat against the work surface) as you slowly push the saw forward, keeping the beam in line with the line of cut .
6.After completion of the cut, release the trigger and turn off the laser light.
FIG. 4
LASER LIGHT
ADJUSTMENT
SCREW
BLADE STORAGE COMPARTMENT
Your Jigsaw is equipped with a blade storage compartment in the dust port of your saw (Fig. 5) . To remove, pull compartment out of dust port in direction of arrow.
Always make sure the blade storage compartment is securely in the dust port to prevent blades from falling out.
FIG. 5
DUST
PORT
BLADE
STORAGE
COMPARTMENT
DUST EXTRACTION
Your jigsaw is equipped with a dust port for dust and chip extraction.
To use this feature, remove blade storage | DUST PORT |
compartment and move dust blower switch to | |
the “OFF” position “O” (Fig. 6). |
|
Attach vacuum hose (optional accessory) to the dust port, and connect opposite end of the hose to a shop vacuum cleaner.
FIG. 6
DUST
BLOWER SWITCH
