Auto Mode Glassfire | Skuttle Indoor Air Quality Products Klin

14	BASIC FIRING STEPS

2 - AUTO MODE (GLASSFIRE)

B E G I N N E R

The GlassMaster LT controller is designed with the beginning fuser in mind. It is important to have a good general understanding of the principals of glass before programming your kiln. Therefore we recommend reading the General Firing Guidelines section of this manual before programming the kiln.

STEP 1 - START IN IDLE STATE

To start programming the kiln must be in an IdLE state. This can be veriﬁed by the display alternating between the cur- rent temperature and the message IdLE. When the kiln is ﬁrst plugged in it will read “PF” indicating that there was a power

interruption. To return to IDLE Mode Press

Press once you are in IDLE Mode to begin the programming process.

STEP 2 - SELECT FIRING MODE

To Display Current Firing Mode Press

The display will read either “AUTO” or “PRO”. If the display reads “AUTO” it is currently set in the GlassFire Mode.

Press to select this mode..

If the display reads “PRO” it is currently set in the Ramp and Hold Mode. Press or to scroll to “AUTO”.

Press to select this mode.

STEP 2 - SELECT SPEED

The controller will display the current ﬁring speed. The display will read SLo, MEd, or FASt for slow, medium, or fast heating rates. Use the chart to the right to help select the appropriate speed for the size of your project.

Press or to scroll to the desired ﬁring