22 | ADVANCED PROGRAMMING |
ADD TEMPERATURE
The Add Temperature feature adds temperature in 5 °F (3 °C) increments to the temperature in segment two. This is considered the Process Temperature since it is holding at the peak temperature of the program. You will only be able to ac- cess this feature when the program is currently in the Segment 2 Hold. To verify the current segment, use the View Segment Feature. It should display HLd2.
Press 
while the program is in Hold 2. The display will read the current segment then display EdIt for approximate-
ly 6 seconds. Press 
while EdIt is displayed. The display will then show SSEG for 6 seconds. Press 
while SSEG is
displayed, to advance it to tME and then Press 
again to display tMP. Press 
to add 5 °F (3 °C) to the Process Tem- perature. The display will then return to showing the current temperature alternately with the Hold Time. The Hold Time will not reset so you may need to use the Add Time Feature to allow it enough time to reach the new temperature.
A D V A N C E D
LOAD MODE
LOADING A STORED RAMP AND HOLD PROGRAM
It is possible to store up to five Ramp and Hold (PRO) programs in the GlassMaster LT. In order to recall a program from memory perform the following steps:
Make sure the controller is in the Advanced State. From Idle Press 
to access the Mode menu. Use the 
or 
keys to select “LOAD” and then Press 
The display will show the last Ramp and Hold (PRO) program selected. Use the 
or 
to select a program number and press 
to Load the program.
The display will now read “REDI”. Press 
to start the program or 
to Review it first.
OPTIONS MODE
EDITING FACTORY SETTINGS
The Options Mode allows you to toggle on or off Modify Glass Fire Mode and toggle between Fahrenheit and Celsius Temperature Scales. It also allows you to RESET all of the factory settings to their original values. Remember when you use the RESET feature it will clear out all of the Ramp and Hold Programs that you have stored (there is a factory set casting program that will be restored in Program 6), change the temperature scale to Fahrenheit, and reset any adjustments you may have made in Modify Glass Fire Mode. To access these Options features follow these instructions:
Make sure the controller is in the Advanced State. From Idle Press 
to access the MODE menu. Use the 
or 
keys to select “OPt” and then Press 
Use the 
or 
to select the feature you wish to edit and press 
to select it.
Use the 
or 
to toggle to your selection and press 
to select it. For RESET simply press 
to select it.
