ADVANCED PROGRAMMING | 21 |
EDIT MODE FEATURES
The Edit Mode Features were designed to allow the artist to adjust the program while it is running. These features are generally used after a visual inspection of the project indicates a change in the program is needed. Edit Mode Features can be accessed from both a GlassFire program and a Ramp and Hold Program. Inspecting the glass while it is firing allows you to make certain adjustments on the very first firing however there are some precautions that should be observed.
The first is of course safety. Whether you are viewing your project by looking through the peephole or lifting the lid, be sure to observe all of the safety tips on page 5.
When lifting the lid to inspect the glass do not hold the lid open too long. The kiln will lose heat and take time to recover. It is important to note that when you release heat from the kiln during the process phase, the final temperature at which your piece is completed may change.
SKIP SEGMENT
The Skip Segment feature advances the program from the current segment to the next segment in the program. The Skip Segment feature can be used to stop the heatwork and advance the program to the annealing segments of the program. This feature should be used after a visual inspection of the glass indicates the effects you desire.
Skip Segment may also be used to speed up a GlassFire program when a slower firing rate is not required. This should
only be used with very small jewelry sized items.
To increase the heating portion of the program you can use Skip Segment to advance from the first segment of any program to the second segment. Since segment 2 in all GlassFire programs has a faster heating rate, it will reach the process temperature faster.
To decrease the amount of time spent during the Annealing segment of the program (segment 4) you may press 
anytime after the desired process has been achieved
Press 
while the kiln is firing. The display will first show the current segment and then display EdIt for approxi- mately 2 seconds. Press 
while EdIt is displayed in the screen. The display will then read SSEG for approximately 6 seconds. While it is displayed Press 
to advance the program.
You may now use the View Segment feature to verify the segment change.
ADD TIME
The Add Time feature adds time in 5 minute increments to the Hold Time in segment two. This is considered the Pro- cess Hold Time since it is holding at the peak temperature of the program. You will only be able to access this feature when the program is currently in the Segment 2 Hold. To verify the current segment use the View Segment Feature. It should display HLd2.
Press 
while the program is in Hold 2. The display will read the current segment then display EdIt for approximate- ly 6 seconds. Press 
while EdIt is displayed. The display will then show SSEG for 6 seconds. Press 
while SSEG is
displayed, to advance it to tME. Press 
to add 5 minutes to the Hold Time. The display will then return to showing the current temperature alternately with the changed Hold Time.
A D V A N C E D
