RESETTING THE INTERNET HUB | APPENDIX |
|
|
The installation of the Internet Hub is divided into two parts - Internal Access and Remote Access. Internal Access allows you to control the Internet Hub within the home network. Remote Access allows you to have control of the Internet
Hub even when you are away from home. Always start with the Internal Access Installation first. After setting up the Internet Hub internally, you may proceed to Remote Access installation.
Refer to the Section 3 [PROGRAMMING THE INTERNET HUB] of this User’s Manual for the Installation.
Resetting the Internet Hub
Please note the IP address should fall into the same subnet (192.168.1.XXX) of your existing network or Cable/DSL router. If this is not the case, you can reset the Internet Hub to factory default and try again or check whether the DHCP Server is enabled in your Cable/DSL router. Please refer to your Cable/DSL router User’s Instructions for details.
1.Unplug the network cable before resetting the Internet Hub.
2.Press and hold the reset button located at the back of the Internet Hub for 5 seconds until the RF and Power LED indicator on the front are steadily on. The LCD should now show “Resetting...”
RESET
3.Shortly after a while the LCD should show the “Skylink” logo with a factory default IP address.
4.Plug in the network cable and go to the ‘Programming the Internet Hub’ instructions found under Section 3 of this User’s Manual
RESETTIING THE INTERNET HUB APPENDIX | 27 |
|
|
|
|
