
Install the Handles | Storage |
Washer Ring
Washer Ring
Attach the two Pan Handles to the Pan Head, by inserting the shorter | Remove the Vertical Tilt Handle from the Pan Head, and screw into the |
handle to the left, and the longer handle to the right. Do not reverse. | back of the Pan & Tilt Handle. |
| Make sure the washer ring on the thread stays on with the handle. |
|
|
|
|
Attaching the camera to the Quick Release Platform
To remove the Quick Release Platform from the Pan Head, turn Quick | Align the length of the Platform along the base of the camera body, and |
Release Lock Lever and lift out Platform from its back. | securely tighten the Mounting Wing Nut. |
Caution
When attaching the camera to the Pan Head, check to make sure that the | The Quick Release Platform can be attached to the camera body in either |
Quick Release Platform is engaged in the catch of the Pan Head before | directions (along the length, or along the width). |
locking the lever. | This feature facilitates your camera set up into the vertical position, simply |
| by the turn of one of the tilt handles. |
Using the Pan Head
Using the Pan Head (Continued)
Caution
Loosen the Vertical Tilt Handle, and the level can be adjusted. | When loosening either the Pan & Tilt Handle, or the Vertical Tilt Handle, take |
| precaution by keeping a firm grip on the handle until the Pan Head is locked |
| down. |
Removing the Head from the Center Column
Use the following instructions if you wish to change heads, or attach | Set the new head, or accessory on the tripod's threaded post, and turn |
accessories. | clockwise until it comes to a stop. |
First, lock the Panning Lock Knob, then grasp the Pan, or Vertical Tilt | Tighten the Panning Lock Knob and turn clockwise slightly more. |
Handle and turn the head, |
|
Three Position Adjustable Legs
To change the angle of each leg, close the Leg slightly, and then pull the Leg |
| After choosing the desired leg angle, securely push in the Adjustment |
Angle Adjustment Lock out. |
| Lock. |
There is a choice of two other angle positions. |
|
|
|
|
|
How to get low level shots |
| Extending/Folding of Tripod Legs |
Loosen the Pan & Tilt Handle, and the head will tilt back and forth.
Loosen the Panning Lock Knob, and the head will rotate along the horizontal direction.
Remove the center column Base Stopper and then, remove the lower part of the center col- umn.
Put the center column Base Stopper on the upper part of the center column.
Then, you can get lower height.
Open the Leg Lock Lever for extending/folding of tripod legs.
Lock the lever tightly at your required position.