How to use the 3 Way pan head
Vertical tilt lock knob
Panning lock knob
Pan handle
Slik’s 3 way Pan head allows your still, or video camera, three indepen- dent movements.
Turn the Pan handle barrel counterclockwise until you feel it loosen, and you can tilt the camera up and down. When you have the angle you want, tighten the Handle in a clockwise direction until it locks in.
To rotate the camera left or right, loosen the Panning lock knob. When you want to lock in at a certain position, tighten the Knob.
For vertical position shots with your still camera, Ioosen the Vertical tilt lock knob, and tilt the Camera platform to the desired position.
Then lock the vertical tilt lock knob.
Extending the tripod legs |
| How to open and close the tripod legs |
|
|
|
|
|
|
Flip up the Leg lock lever to extend or shorten any of the individual leg sections to the desired length, and press the leg lock lever flush against the leg to lock.
For greater stableness, use the thicker leg columns first.
Holding two legs, one in each hand, tilt the tripod on its third leg.
Pull the two legs you are holding outward, and all three legs will open at once. Open until the Center column ring is seated at the very bottom of the Center column.
To close the legs, be sure to first raise the Center column ring up slightly, and then push the legs close.
Elevating the center column |
| Adjusting elevation tension |
|
|
|
|
|
|
Loosen the Center column locking collar, and turn the Elevation crank handle to raise or lower the Center column.
Always be certain to tighten the Locking collar before taking your hands off the Crank handle to prevent accidental falls.
The “Center lock” mechanism featured in this model prevents unwanted camera movements which often occurs when tightening the center column.
Use the Center column tension adjustment tube located around the Center column if you wish to adjust the tension of the center column movement.
Rotate the tube counterclockwise to increase tension. For less tension, rotate clockwise.
Care of the Tripod
・DO NOT apply any grease or oil to this product. ・Clean with a mild detergent and a soft cloth only. ・DO NOT use close to flame. Avoid extreme heat.
OIL THINNER
Slik Corporation reserves the right to make changes in design and/or improvements on the products without any obligation and advanced notice.
SLIK CORPORATION
853 Kayama, Hidaka City, Saitama