99-00881-20 A0 Appendix A: Remote Management of Your Interactive Whiteboard System 43
Query Commands
* This command bypasses internal buffering and generates a response immediately.
Projector Power Control Commands
** You must send the off command twice. The first command displays an on-screen message and the second
command shuts off the system. You must send the second command within five seconds before the first
command times out.
Command Result Response (On-Screen)
get fwver Displays the ECP’s firmware version* FW version = #
get bootver Displays the ECP’s bootloader version* Bootloader version = #
get input Displays the projector’s input* Input = #
get powerstate Displays the projector’s power state (Idle, Powering, On
or Cooling)* Powerstate = #
get brightness Displays the projector ’s brightness setting Brightness = #
get contrast Displays the projector’s contrast setting Contrast = #
get volume Displays the projector’s volume setting Volume = #
get lamphrs Displays the number of hours the projector lamp has been in use Lamp hours = #
get syshrs Displays the number of hours the interactive whiteboard system
has been in use System hours = #
get pjfwver Displays the projector’s firmware version Projector FW Version = #
get pjserial Displays the projector’s serial number Projector Serial Number = #
Commands Result Response (On-Screen)
off now Turns off the Unifi 45 projector immediately Turning off
off Turns off the Unifi 45 projector normally** Turning off
on Turns on the Unifi 45 projector normally Turning on